Home > Report Designer > Report Controls > Cross-band Box

Cross-band Box

The Cross-band Box control allows you to draw a rectangle through several bands. This can be useful if it is required to visually encompass a section consisting of multiple band areas.

Another cross-band control available is the Cross-band Line .

In the Property Grid , the Cross-band Box control's properties are divided into the following groups.

• Borders, Border Color and Border Width
  

  Specify border settings for the control.

• Formatting Rules

  Invokes the Formatting Rules Editor, allowing you to choose which rules should be applied to the control during report generation, and define the precedence of the applied rules. 

• Anchor Vertically
  

  Specifies the vertical anchoring style of the control, so that after page rendering it stays attached to the top control, bottom control, or both.

• Visible
  

  Specifies whether the control should be visible in print preview.

• Tag
  

  This property allows you to add some additional information to the control; for example its id, by which it can then be accessible via scripts.

• (Name)
  

  Determines a control's name, by which it can be accessed in the Report Explorer, Property Grid or via scripts.

• End Band
  

  Determines a band, in which the control finishes drawing.

• End Point
  

  Determines the end point (from a band's upper left corner) where the control finishes drawing.

• Location
  

  Specifies the control's location, in report measurement units.

• Snap Line Margin
  

  Specifies the margin (in report measurement units), which is to be preserved around the control when it is aligned using Snap Lines, or when other controls are aligned next to it.

• Start Band
  

  Determines a band, in which the control starts drawing.

• Start Point
  

  Determines the starting point (from a band's upper left corner) where the control starts drawing.

• Width
  

  Specifies the width of the Box, in report measurement units.

See also